V.35/X.21/RS-232 Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
293
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
V.35/X.21/RS-232 CONFIGURATION COMMANDS
This section provides details about the commands that are used in configuring the
V.35/X.21/RS-232 interface.
T
O CONFIGURE A SERIAL INTERFACE
EXAMPLE
ALU(config)#interface Serial 0/0
ALU(config-if Serial0/0)#
T
O BRING UP/DOWN A SERIAL (V.35/X.21/RS-232) INTERFACE
EXAMPLE
The following example administratively brings up the V.35/X.21/RS-232 interface:
ALU(config-if Serial0/0)# no shutdown
The following example administratively brings down the V.35/X.21/RS-232
interface:
ALU(config-if Serial0/0)# shutdown
Command (in CM) Description
interface Serial <slot/port> Enters Serial Interface Configuration
Mode.
This command is entered in the
Configuration Mode to configure a serial
interface in a specific slot/port of the
V.35/X.21/RS-232 card.
Command (in ICM) Description
no shutdown This command is entered in the interface
configuration mode to administratively
bring up the interface.
shutdown This command is entered in the interface
configuration mode to administratively
bring down the interface.
To Next Page
Loading...
Need help?
General
