T1E1 Line Card
Left running head:
Chapter name (automatic)
276
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T1 CONFIGURATION COMMANDS
This section comprises the commands that are used in configuring the T1
controller.
T
O SET THE CARD TYPE TO T1
E
XAMPLE
ALU(config)# card type T1 0
Note: The line card is not functional until card type is set to either T1 or E1. Reboot/Reload
the chassis to change the card type, which will remove the previous configuration.
T
O CONFIGURE T1 CONTROLLER
E
XAMPLE
ALU(config)# controller T1 0/0
ALU(config-controller T1)#
Command (in CM) Description
card type {E1|T1} <slot> Use this command to set the card
type.
Use T1 keyword to set the card type
to T1.
Command (in CM) Description
controller {E1|T1} <slot/port> This command configures a E1 or T1
controller.
Use T1 keyword to configure a port in
the T1 mode. The T1 has a bandwidth
of 1.544 Mbps.
To Next Page
Loading...
