Alcatel-Lucent OmniAccess 5740 - Organization; Parti - Introduction; Part II - LAN Interfaces

OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Left running head:
Chapter name (automatic)
2
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
ORGANIZATION
The chapters in the CLI Configuration Guide are organized into seven parts.
PART I - INTRODUCTION
The first part provides an introduction to CLI, “The Command Line Interface” in
Chapter 2. This is a preparatory chapter that describes the CLI configuration
considerations, tools required, an overview of the Command Line Interface and
procedures that should be performed before the actual configuration.
Chapter 3 “System Configuration and Monitoring” provides an overview of the
system level commands required to troubleshoot, monitor, connect the system to
the network. This chapter also includes commands for Inband and Out-of-band
management, setting system parameters, software management, configuration
management, AAA services, SNMP, etc. The various commands described
include SSH, Telnet, show version, update, show environment, etc.
Chapter 4 “Virtual Router Redundancy Protocol” details a study on VRRP
implementation on the OmniAccess 5740 USG. It is a method of providing
nonstop path redundancy and gateway redundancy for an enterprise network by
sharing protocol and Media Access Control (MAC) addresses between redundant
gateways.
PART II - LAN INTERFACES
This part introduces the commands and steps to configure the LAN interfaces. It
gives a succinct overview on the Ethernet Interface configuration in Chapter 5
“Ethernet Interfaces on SE”.
Chapter 6 “Layer 2 Switching Configuration” deals with the L2 switching
Configuration on the OmniAccess 5740 USG. The chapter is organized with the
L2 switching overview, configuration details in the first few sections and the
configuration scenario in the end to give a real time example for configuring
switching.
Chapter 7 “Per VLAN Spanning Tree +” details the VLAN commands in
switching.
Chapter 8 “Integrated Routing and Bridging” deals with Switching
configuration integrated with routing.
Chapter 9 “802.1X Port-Based Authentication” describes how to configure
IEEE 802.1X port-based authentication on the OmniAccess 5740 USG.
Chapter 10 “Port Monitoring” chapter details the commands used to configure
Port Monitoring on the OmniAccess 5740 USG.