Point-to-Point Protocol over Ethernet (PPPoE)
Left running head:
Chapter name (automatic)
362
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
PPPOE OPTIONAL PARAMETERS
TO CONFIGURE PPPOE SERVICE NAME
The PPPoE Service Selection feature uses service names to enable PPPoE
servers to offer PPPoE clients a selection of services during call setup. The client
chooses one of the services offered, and the service is provided when the PPPoE
session becomes active.
E
XAMPLE
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)# pppoe service-name ISP1
ALU(config-if GigabitEthernet3/0)# no pppoe service-name
Note: The PPPoE service-name configured on OmniAccess 5740 USG should match the
service-name supported on the server.
If “service-name” is not configured, then the client accepts any service offered by the
PPPoE server.
Command (in ICM) Description
pppoe service-name <name> This command is used to configure the
PPPoE client to request a particular
service (e.g. web-access) supported by
the PPPoE server.
Service name can be of maximum length
50 characters.
no pppoe service-name The “no” command removes the service
name configured.
To Next Page
Loading...
