Alcatel-Lucent OmniAccess 5740 - Show Commands in TF

TF Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
965
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
SHOW COMMANDS IN TF
TO VIEW TF POLICY DETAILS
EXAMPLE
ALU(config)# show transparent-forward
!
! Transparent-forward configuration
!
interface GigabitEthernet3/1
transparent-forward interface GigabitEthernet3/0
exit
!
transparent-forward tf
pass-through protocol nonip
exit
!
interface GigabitEthernet3/0
transparent-forward tf interface GigabitEthernet3/1
exit
!
ALU(config)#
Command (in SUM/CM) Description
show transparent-forward
[<name>]
This command is used to view all the TF
policies configured in the system.
If a TF policy is specified then the details
of the specific TF policy is displayed.
This command also displays the
interfaces on which these policies are
applied.