Multilink Point to Point Protocol
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
367
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
CHAPTER 17 MULTILINK POINT TO POINT PROTOCOL
This chapter includes the commands for configuring Multilink Point-to-Point
Protocol (MLPPP) encapsulation on a T1 or an E1 interface or a Serial (V.35/X.21)
interface. You are required to refer to the “T1E1 Line Card” and “Universal Serial
Port (USP) Line Card” chapters before proceeding to this.
For instructions on using the MLPPP commands and descriptions on each of their
parameters, refer to the OmniAccess 5740 Unified Services Gateway CLI
Command Reference Guide.
The chapter is divided into the following sections:
• “MLPPP Overview”
• “MLPPP Configuration”
• “MLPPP Configuration Example”
CHAPTER CONVENTIONS
Acronym Description
CM Configuration Mode - ALU (config)#
CPE Customer Premises Equipment
ICM Interface Configuration Mode - ALU (config-interface name)#
IPCP IP Control Protocol
FR Frame Relay
LCP Link Control Protocol
MLPPP Multi Link Point to Point Protocol
MRRU Maximum Receive Reconstructed Unit
MTU Maximum Transmission Unit
PPP Point-to-Point Protocol
SPE Service Provider Equipment
SSHNF Short Sequence Header Number Format
SUM Super User Mode - ALU#
To Next Page
Loading...
Need help?
General
