Alcatel-Lucent OmniAccess 5740 - VRF-CE CLI Commands

Virtual Routing and Forwarding
Left running head:
Chapter name (automatic)
664
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
VRF-CE CLI COMMANDS
This section details the commands used in configuring VRF-CE.
T
O CONFIGURE VRF
E
XAMPLE
ALU(config)# ip vrf ALU-vrf
ALU(config-vrf)#
Note: Maximum number of VRFs supported is 64.
T
O CONFIGURE DESCRIPTION FOR A VRF
E
XAMPLE
ALU(config-vrf)# description ALU-routing
Command (in CM) Description
ip vrf <vrf-name> This command is used to configure a VRF.
This enters the VRF Configuration Mode.
no ip vrf <vrf-name> This command deletes the configured VRF.
All routing protocol configuration within the
VRF is removed.
Command (in VRF CM) Description
description <description-
string>
This command is used to specify description
for a VRF.