Alcatel-Lucent OmniAccess 5740 - HDLC Configuration Commands

HDLC Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
309
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
HDLC CONFIGURATION COMMANDS
This section details the HDLC configuration commands.
T
O SET ENCAPSULATION TO ITS DEFAULT (HDLC)
Enter this command in the Interface Configuration Mode.
E
XAMPLE
ALU(config-if Serial0/0:0)# no encapsulation frame-relay
T
O CONFIGURE HDLC ENCAPSULATION
EXAMPLE
ALU(config-if Serial0/0:0)# encapsulation hdlc
Command (in ICM) Description
no encapsulation {frame-relay
|ppp|mlppp|mlfr}
This command is used to configure
encapsulation on the interface to HDLC.
This command is applicable only if the
encapsulation is already set to Frame
Relay or PPP.
Command (in ICM) Description
encapsulation hdlc This command is entered in the Interface
Configuration Mode.
This command is used to configure
encapsulation on an interface to HDLC.