Alcatel-Lucent OmniAccess 5740 - Show Command

Universal Serial Port (USP) Line Card
Left running head:
Chapter name (automatic)
298
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
SHOW COMMAND
TO VIEW INTERFACE DETAILS
EXAMPLE
ALU# show interfaces Serial 0/0
Serial 0 is up, line protocol is up
X.21 DTE Serial attached
Internet address is 15.0.0.1/8
MTU 1500 bytes, BW 2048 Kbit, DLY 0 usec,
reliability 0/255, txload 0/255, rxload 0/255
loopback not set
Encapsulation hdlc, keepalive set (10 sec)
Last input never, output never, output hang never
Last claring of "show interface" counters never
Queueing strategy: fifo
Output queue: 0 0 (size/max) 0 drops:Input queue 0/0 (size/max) 0 drops
Conversations: 0/0/0 (active/max active/max total)
Reserved Conversations: 0/0 (allocated/max allocated)
Available Bandwidth 2048 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
12105 packets input, 167342 bytes, 0 no buffer
0 Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
31734317 packets output, 3037327615 bytes, 0 no buffer
8833175 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
Note: You can view the details of the interface in the Interface Configuration Mode with a
‘show’ command without entering into the user mode.
Command (in SUM/CM) Description
show interfaces Serial [<slot/
port>]
Displays the configuration details for the
specified interface.