Ethernet Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
167
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
ETHERNET CONFIGURATION
Refer to the following sections to configure an Ethernet interface on the
OmniAccess 5740 USG.
ETHERNET INTERFACE CONFIGURATION STEPS
This section lists the step by step instructions to configure Ethernet interface.
Step 1: Enter into Configuration Mode.
ALU# configure terminal
ALU(config)#
Step 2: Configure Gigabit Ethernet interface. See “To Configure GigE Interface”
Step 3: Administratively bring up the interface. See “To Bring Up/Down a GigE
Interface”
Step 4: Configure IP address for the interface. See “To Configure IP Address for
the Interface”
Step 5: Configure parameters that are optional on the interface.
• Configure Duplex Operation on the interface. See “To Configure Duplex
Operation”
• Configure Flow control on the interface. See “To Configure Flow Control”
• Configure MTU on the interface. See “To Configure MTU (Maximum
Transmission Unit) on the Interface”
• Configure Speed on the interface. See “To Configure Speed”
Step 6: View the configuration details on the interface. See “Ethernet Interface
Show Commands”.
Step 7: Clear interface statistics. See “Ethernet Interface Clear Commands”.
To Next Page
Loading...
Need help?
General
