Alcatel-Lucent OmniAccess 5740 - Configure Logical Interface

The Command Line Interface
Left running head:
Chapter name (automatic)
26
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
ALU# configure
Enter configuration commands, one per line. End with CNTL/Z.
ALU(config)# interface GigabitEthernet 3/0
ALU(config-if GigabitEthernet3/0)# end
ALU#
ALU# configure
Enter configuration commands, one per line. End with CNTL/Z.
ALU(config)# interface GigabitEthernet 3/0
ALU(config-if GigabitEthernet3/0)# ^C
ALU#
ALU# configure
Enter configuration commands, one per line. End with CNTL/Z.
ALU(config)# interface GigabitEthernet 3/0
ALU(config-if GigabitEthernet3/0)# exit
ALU(config)#
ALU# configure
Enter configuration commands, one per line. End with CNTL/Z.
ALU(config)# interface GigabitEthernet 3/0
ALU(config-if GigabitEthernet3/0)# top
ALU(config)#
INITIAL SETUP
Whenever the system configuration is empty, you are automatically entered into
the initial setup program, which takes you through the basic configuration steps.