OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Left running head:
Chapter name (automatic)
4
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
PART IV - PACKET CLASSIFICATION
This part consists of Chapter 22 “Common Classifiers” that focuses on
configuring the Common Classifier commands. These commands are generic
across all applications. You are required to have a thorough knowledge of this
chapter before you proceed to configure the NATs, Filters, etc. This chapter
provides a concise overview on the concepts of creating rules, match-lists, lists,
etc.
PART V - ROUTING PROTOCOLS
The aim of this part is to get the most out of addressing and routing. The routing
function moves data through the network efficiently and finds new paths when
network changes occur. Routing also affects how large the network can grow -
that is, the complexity of the topology and the stability of the network as it
expands. All the chapters in this part focus on configuring the routing services.
Chapter 23 “Protocol Independent Features” provides commands that are
generic across all routing protocols. You are required to have a thorough
knowledge of this chapter before you proceed to configure the routing protocols.
Chapter 24 “Routing Information Protocol” and Chapter 25 “Border Gateway
Protocol” and Chapter 26 “Open Shortest Path First” provides configuration
commands for configuring RIP, BGP and OSPF routing protocols.
Chapter 27 “Multicast Routing” provides Multicast routing configuration on the
OmniAccess 5740 USG.
Chapter 28 “Policy Based Routing” covers the Policy Based Routing (PBR)
configuration on the OmniAccess 5740 USG.
Chapter 29 “Virtual Routing and Forwarding” covers the Virtual Routing and
Forwarding Customer Edge (VRF-CE) configuration on the OmniAccess 5740
USG. VRF-CE is a feature that enables a service provider to support two or more
VPNs, where IP addresses can be overlapped among the VPNs.
To Next Page
Loading...
Need help?
General
