Alcatel-Lucent OmniAccess 5740 - Ethernet Interface Show Commands

Ethernet Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
173
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
ETHERNET INTERFACE SHOW COMMANDS
TO VIEW INTERFACE CONFIGURATION
EXAMPLE 1
ALU# show interfaces
GigabitEthernet3/0 is up, line protocol is up
Hardware address is 0000.2222.3333 (0000.2222.3333)
Internet address is 2.2.2.1/24
MTU 1500 bytes, BW 0 Kbit, DLY 0 usec,
reliability 0/255, txload 0/255, rxload 0/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 0, loopback not set
Keepalive not set
Auto-duplex, Auto speed, 1000BaseTx/Fx
ARP type: ARPA, ARP Timeout never
Last input never, output never, output hang never
Last clearing of "show interface" counters never
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
5985 packets input, 674968 bytes, 0 no buffer
Received 12 broadcasts, 2 runts, 0 giants
24 input errors, 21 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 4583 multicast, 0 pause input
4766 packets output, 486524 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
2 lost carrier, 2 no carrier, 0 pause output
0 output buffer copied, 0 interrupts, 0 failures
E
XAMPLE 2
ALU# show interfaces GigabitEthernet 3/0
GigabitEthernet3/0 is up, line protocol is up
Hardware address is 0000.1111.2222 (0000.1111.2222)
Internet address is 1.1.1.1/24
MTU 1500 bytes, BW 0 Kbit, DLY 0 usec,
reliability 0/255, txload 0/255, rxload 0/255
Encapsulation 802.1Q Virtual LAN, Vlan ID 0., loopback not set
Keepalive not set
Auto-duplex, Auto speed, 1000BaseTx/Fx
ARP type: ARPA, ARP Timeout never
Last input never, output never, output hang never
Last clearing of "show interface" counters never
5 minute input rate 0 bits/sec, 0 packets/sec
Command (in CM/ICM) Description
show interfaces [<interface-
name>]
This command displays traffic and all the
corresponding details of all the interfaces
configured.
If interface name is specified,
corresponding details for a specified
interface is displayed.