Ethernet Interfaces on SE
Left running head:
Chapter name (automatic)
174
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
5 minute output rate 0 bits/sec, 0 packets/sec
5397 packets input, 380818 bytes, 0 no buffer
Received 21 broadcasts, 1 runts, 0 giants
2 input errors, 1 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 2465 multicast, 0 pause input
2503 packets output, 212146 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
1 lost carrier, 2 no carrier, 0 pause output
0 output buffer copied, 0 interrupts, 0 failures
ALU#
TO VIEW GIGE INTERFACE DETAILS
EXAMPLE
ALU(config-if GigabitEthernet3/0)# show
GigabitEthernet3/0 is up, line protocol is up
Hardware is Intel 82546, address is 0011.8b00.2728 (0011.8b00.2728)
Internet address is 9.9.9.9/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 0 usec,
reliability 0/255, txload 0/255, rxload 0/255
Loopback not set
Encapsulation ARPA, keepalive not set
Auto-duplex, 1000Mb/s, 1000BaseTx/Fx
ARP type: ARPA, ARP Timeout never
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/0 (size/max), 0 drops; Input queue 0/0 (size/max), 0 drops
5 minute input rate 344 bits/sec, 1 packets/sec
5 minute output rate 8 bits/sec, 0 packets/sec
68 packets input, 5108 bytes, 0 no buffer
Received 39 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
3 packets output, 192 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer copied, 0 interrupts, 0 failures
Command (in ICM) Description
show This command is used in the Interface
Configuration Mode.
This command displays traffic on the
GigE interface.
To Next Page
Loading...
