Integrated Routing and Bridging
Left running head:
Chapter name (automatic)
218
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
IRB COMMANDS
TO CONFIGURE VLAN INTERFACE
E
XAMPLE
ALU(config)# interface vlan 10
ALU(config-if Vlan 10)#
T
O VIEW VLAN STATISTICS
E
XAMPLE
ALU(config)# show interfaces vlan 10
vlan10 is up
Hardware is none, address is 0011.8b00.0e28 (0011.8b00.0e28)
Internet address is 10.91.0.1/24
MTU 1500 bytes, BW 0 Kbit, DLY 0 usec, reliability 0/255, txload 0/255,
rxload 0/255
loopback not set, Keepalive not set
Auto-duplex, Auto, 1000BaseTx/Fx
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/0(size/max),0 drops;Input queue 0/0 (size/max), 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
2034961 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors,0 CRC, 0 frame,0 overrun,1580 ignored
0 watchdog, 0 multicast, 0 pause input
2035879 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
Command (in CM) Description
interface vlan <1-4094> This command is used to configure a
VLAN interface.
Command (in SUM/CM) Description
show interfaces vlan <1-4094> This command displays the VLAN
statistics of the VLAN-ID specified on the
interface.
To Next Page
Loading...
