Alcatel-Lucent OmniAccess 5740 - Show Commands in IGMP

Multicast Routing
Left running head:
Chapter name (automatic)
634
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
SHOW COMMANDS IN IGMP
TO VIEW IGMP GROUP INTERFACE INFORMATION
EXAMPLE
ALU# show ip igmp groups
Interface Group-Address Last-Reporter Uptime Expires(sec:msec)
GigabitEthernet3/0 224.1.1.1 3.3.3.4 0:0:51 217:89
GigabitEthernet3/1 224.0.1.40 5.5.5.5 4:12:42 147:509
GigabitEthernet3/1 225.5.5.5 5.5.5.5 0:0:7 252:620
TO VIEW IGMP INTERFACE INFORMATION
EXAMPLE
ALU# show ip igmp interface
GigabitEthernet3/0 Internet address 7.7.7.3 Mask 255.255.255.0
Host version 2 Router Version 2
Query Interval = 125
Querier Timeout = 255
Max query response time = 10
Last member query count = 2
Last member query response time = 1000
Access Group set = 0
Number of joins on this interface = 84
Number of leave message on this interface = 7
Querier on this interface = 7.7.7.3
Interface DR is 7.7.7.3
Total groups on this interface 1
Group 1 224.1.1.1
Command (in SUM/CM) Description
show ip igmp groups [<group-
address>] [<interface-name>]
This command displays all the
multicast groups joined.
You can enter the interface name to
see multicast groups on that interface.
Command (in SUM/CM) Description
show ip igmp interface
[<interface-name>]
This command displays all interfaces
on which the IGMP is enabled, and
displays configured/default values of
the IGMP interface parameters.