Alcatel-Lucent OmniAccess 5740 - Verifying Multicast Routing

Multicast Configuration on OmniAccess 5740 USG
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
641
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
VERIFYING MULTICAST ROUTING
Show command outputs on router R3 is given. It shows the outgoing interface list
for each (*,G) entry. You can use "show ip multicast traffic" command to verify the
packet reception and forwarding.
R3(config)# show ip pim state-info
PIMv2 State information
Flags: M - Nexthop from Mroute, T - Terminating, A - Reported by IGMP
K - KeepAlive Timer Running, S - SPT bit set
(*,225.5.5.5), JOINED 00:01:10/00:00:49, RP 3.3.3.2, flags:
Incoming interface: GigabitEthernet3/1, RPF neighbor 3.3.3.2
Downstream interface state:
Serial0/0:0, 00:01:10, flags:
(*,G): JOIN ET:00:03:20 PPT:00:00:00
inherited_olist: Serial0/0:0
(*,227.7.7.7), JOINED 00:09:26/00:00:34, RP 3.3.3.2, flags:
Incoming interface: GigabitEthernet3/1, RPF neighbor 3.3.3.2
Downstream interface state:
GigabitEthernet3/0, 00:09:26, flags:
(*,G): JOIN ET:00:03:02 PPT:00:00:00
Serial0/0:0, 00:00:16, flags:
(*,G): JOIN ET:00:03:14 PPT:00:00:00
inherited_olist: GigabitEthernet3/0 Serial0/0:0
R3(config)#
R3(config)# show ip mroute
IP Multicast Forwarding Information Base
Flags: R - RP-bit set, T - SPT-bit set
F - Register flag, J - Joined
(*, 225.5.5.5), uptime 0:01:59, flags:
Incoming Interface: GigabitEthernet3/1, RPF failures 0
Outgoing Interfaces (1):
Serial0/0:0
(*, 227.7.7.7), uptime 0:10:15, flags:
Incoming Interface: GigabitEthernet3/1, RPF failures 0
Outgoing Interfaces (2):
GigabitEthernet3/0
Serial0/0:0
R3(config)#
R3(config)# show ip multicast traffic
IP Multicast statistics:
Rcvd: 11134 total, 4802 link local
Sent: 5973 forwarded, 0 send register
5 send assert, 1 first data pkt notice
Errors: 5 rpf failure, 5 drop
R3(config)#