Ethernet OAM (Operations, Administration, and Maintenance)
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
395
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
CHAPTER 19 ETHERNET OAM (OPERATIONS,
ADMINISTRATION, AND MAINTENANCE)
This chapter covers the commands used to configure Ethernet OAM (Operations,
Administration, and Maintenance) feature on OmniAccess 5740 USG.
For instructions on using the commands and to get a detailed description on each
of their parameters, refer to OmniAccess 5740 Unified Services Gateway CLI
Command Reference Guide.
CHAPTER CONVENTIONS
Acronym Description
AIS Alarm Indication Signal
CM Configuration Mode - ALU (config)#
CFM Connectivity Fault Management
CCM Continuity Check Message
DoSAP Domain Service Access Point
DMM Delay Measurement Message
DMR Delay Measurement Reply
ETH-AIS Ethernet Alarm Indication Signal
ICM Interface Configuration Mode - ALU (config-if interface name)#
OAM Operations, Administration, and Maintenance
OAM-DA CM OAM Domain Association Configuration Mode - ALU (config-oam-
domain-association)#
LAN Local Area Network
LTM Link Trace Message
LTR Link Trace Reply
LBR Loopback Reply
MA Maintenance Association
MEP Maintenance Association End Point
To Next Page
Loading...
Need help?
General
