EasyManuals Logo

Alcatel-Lucent OmniAccess 5740 Cli Configuration Guide

Alcatel-Lucent OmniAccess 5740
1225 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #294 background imageLoading...
Page #294 background image
T1E1 Line Card
Left running head:
Chapter name (automatic)
268
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
E1 SHOW COMMANDS
TO VIEW THE E1 CONTROLLER CONFIGURATION
The show controller E1 command displays the status of the E1 controller and
displays information about clocksources and other settings for the ports.
E
XAMPLE
ALU# show controller
E1 1/0 is administratively down.
E1 1/1 is administratively down.
E1 1/2 is up.
Line Card type is Channelized E1
Line termination is 120ohm
No Alarm Detected
Framing is crc4, Line Code is hdb3, Clock Source is internal
Total Data (Since last clearing of counters)
1 Line Code Violation, 0 Framing Errors
0 CRC Errors, 0 Far End Block Errors
E1 1/3 is administratively down.
ALU# show controller E1 1/2
E1 1/2 is up.
Line Card type is Channelized E1
Line termination is 120ohm
No Alarm Detected
Framing is crc4, Line Code is hdb3, Clock Source is internal
Total Data (Since last clearing of counters)
1 Line Code Violation, 0 Framing Errors
0 CRC Errors, 0 Far End Block Errors
Command (in SUM/CM) Description
show controller [{E1|T1}
<slot/port>]
This command displays controller status
that is specific to the controller hardware.

Table of Contents

Other manuals for Alcatel-Lucent OmniAccess 5740

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent OmniAccess 5740 and is the answer not in the manual?

Alcatel-Lucent OmniAccess 5740 Specifications

General IconGeneral
BrandAlcatel-Lucent
ModelOmniAccess 5740
CategoryGateway
LanguageEnglish

Related product manuals