MLFR Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
393
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO CONFIGURE THE RETRY COUNT
Retry count is the number of times the bundle link will send out a hello message
before any acknowledgment is received from its peer.
E
XAMPLE
ALU(config-if Serial0/0:0)# mlfr retry-count 3
ALU(config-if Serial0/0:0)# no mlfr retry-count 3
MLFR SHOW COMMANDS
TO VIEW MLFR CONFIGURATION
EXAMPLE
ALU(config)# show interfaces mlfr 1
mlfr1 is up, line protocol is up
Internet address is 192.168.1.1/24
Bundle id is mlfr1, keepalive set (10 sec)
LMI enq sent 26219, LMI stat recvd 325, LMI upd recvd 0, DTE LMI up
LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0
LMI DLCI 0 LMI type is CCITT(q933a) frame relay DTE
MTU 1500 bytes, BW 3072 Kbit, DLY 0 usec,
reliability 255/255, txload 0/255, rxload 0/255
Encapsulation mlfr-bundle, loopback not set
Last input never, output never, output hang never
Last clearing of "show interface" counters never
614 packets input( 325 controld packets, 289 data packets),34295 bytes
26599 packets output( 26216 controld packets, 383 data packets),458430 bytes
53 packets dropped 0 giant packets
Command (in ICM) Description
mlfr retry-count <1-5> This command configures the retry count
to the number specified. The range of
this number is from 1 to 5.
no mlfr retry-count <1-5> This command resets the retry count to
its default, i.e., 2.
Command (in SUM/CM) Description
show interfaces mlfr [<1-256>] Displays the configuration of the MLFR
bundle interface specified.
show mlfr [<1-256>] Displays the protocol status on the
member links of the specified MLFR
bundle interface.
show interfaces Serial [<slot/
port:channel>]
Use this command to verify if MLFR is
the current encapsulation on the
interface, and to check the interface
details.
To Next Page
Loading...
