Link Fragmentation and Interleaving (LFI)
Left running head:
Chapter name (automatic)
464
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
LFI - FR SHOW COMMANDS
TO VIEW LFI-FR CONFIGURATION
EXAMPLE
ALU(config)# show interfaces Serial0/0:0
Serial1/0:0 is up, line protocol is up
Internet address is 3.3.3.2/24
MTU 1500 bytes, BW 1536 Kbit, DLY 0 usec,
Fragment-size 80, slippage mru 16
reliability 255/255, txload 0/255, rxload 0/255
Loopback not set
Encapsulation frame-relay, keepalive not set
LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0, DTE LMI down
LMI enq recvd 0, LMI stat sent 0, LMI upd sent 0
LMI DLCI 0 LMI type is Autosense frame relay DTE
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue: 0/0 (size/max) 0 drops; Input queue: 0/0 (size/max) 0 drops
Conversations: 0/0/0/0 (active/max active/max total)
Reserved Conversations: 0/0 (allocated/max allocated)
Available Bandwidth 1536 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Timeslot(s) Used:1-24 (64Kbps each), Transmitter delay is 0 flags
Command (in SUM/CM/ICM) Description
show interfaces serial <slot/
port>
Displays the configured value of
fragment size and slippage MRU
configured on the specified interface.
To Next Page
Loading...
