Alcatel-Lucent OmniAccess 5740 - Time-Range;Timer Configuration; Time-Range Configuration Commands

Time-range/Timer Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
783
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TIME-RANGE/TIMER CONFIGURATION
This section describes configuration of the time-range/timer across various
applications. It is divided into the following sections:
• “Time-range Configuration Commands”
• “Time-range Show Command”
TIME-RANGE CONFIGURATION COMMANDS
This section lists the commands used in configuring time-range.
T
O CONFIGURE A TIME-RANGE
Time-range enters the Time-range sub-configuration mode. Here, the time
configured for scheduling is the local time and not the GMT time. Therefore, it has
the option to permit automatic changing to/from daylight savings time.
Note: User must issue “clock” command to set the clock in OmniAccess 5740 USG, so that
the time-range configuration can take effect precisely.
E
XAMPLE
ALU(config)# time-range t1
ALU(config-time-range-t1)#
ALU(config)# no time-range t1
Command (in CM) Description
time-range <name> This command is used to configure a
time-range object that can be used
across applications.
no time-range <name> This command is used to delete a
specific time-range.