Alcatel-Lucent OmniAccess 5740 - 23 Protocol Independent Features; Chapter Conventions

Protocol Independent Features
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
501
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
CHAPTER 23 PROTOCOL INDEPENDENT FEATURES
This chapter describes configuration of the IP routing protocol-independent
features. Refer to the following sections to configure Protocol Independent
features on your system:
• “Protocol-Independent Configuration”
• “Protocol-Independent Configuration Commands”
For instructions on using the commands and descriptions on each of their
parameters with the corresponding default values, refer to the OmniAccess 5740
Unified Services Gateway CLI Command Reference Guide.
CHAPTER CONVENTIONS
Acronym Description
CM Configuration Mode - ALU (config)#
ICM Interface Configuration Mode - ALU (config-if)#
Extended IP
Access list CM
Configuration Mode - ALU (config-ext-nac1)#
RCM Router Configuration Mode - ALU (config-router ospf)#
Route map CM Route Map Configuration Mode -ALU (config-route-map)#
SUM Super User Mode - ALU#
Standard IP
Access list CM
Configuration Mode - ALU (config-std-nac1)#