System Monitoring and Troubleshooting
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
110
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Acceptable voltage range is +/- 6%. Acceptable temperatures vary depending on
the card type, but generally range from 0 - 60
0
C. Warnings will be logged and the
fan speed adjusted if any of the cards show a temperature greater than 50
0
C.
SYSTEM HARDWARE INFORMATION
The show chassis command provides a physical inventory of the chassis’
components, including parts that are in meta-slots (i.e., not line cards). Generally,
it depicts the static information about the hardware configuration. The command
can be used for a specific slot or to view information for the entire chassis.
The command reports on the pluggable as well as non-pluggable (front panel)
components of the system. These reports are available in common format. This
command is available at all configuration modes.
EXAMPLE
ALU(config)# show chassis
Physical inventory at Thu Jul 8 14:49:33 2010
System started approximately Thu Jul 8 14:29:53 2010
Uptime is 0 days 0 hours 22 minutes 10 seconds
T1/E1 - Four port T1/E1 (active)
Slot number: 1
Part number: 902604-90
Manufacturer: ALU
Description: Four port T1/E1
Serial number: DG0820000252
Version: 03
Revision: 00
LoL firmware version: 2.2.71
Loader version: 2.35
ALU-OS version: 3.0.0
SE - Services engine (active)
Slot number: 3
Part number: 902601-90
Manufacturer: ALU
Description: Services engine
Serial number: DG0818000126
Version: 02
Revision: 00
CPU Version: 1 (Low Power Opteron)
Opteron CPU Version: 1
Command (in SUM/CM) Description
show chassis [slot <0-3>] This command provides a physical
inventory of the chassis components for
a specific slot or for the entire system. It
does not indicate the liveness of the
elements listed.
To Next Page
Loading...
