RIP Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
551
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
RIP SHOW COMMANDS
The following show commands are described in the example given below:
T
O VERIFY ROUTE SUMMARIZATION
EXAMPLE
The show ip protocols command in SUM can be used to verify summarization
configuration as shown in the example below:
ALU# show ip protocols
Routing Protocol is "rip"
Sending updates every 30 seconds, next due in 27 seconds
Invalid after 180 seconds, hold down 180, flushed after 240 seconds
Default redistribution metric is 3
Redistributing External Routes from:
connected metric 3
static metric 4
Default version control: send version 2, receive version 2
Automatic network summarization is in effect
Outgoing update filter list for all interfaces is not set
Incoming update filter list for all interfaces is not set
Interface Send Recv Key-chain
GigabitEthernet3/1 2 2
loopback1 2 2
Routing for Networks:
1.0.0.0
4.0.0.0
Routing Information Sources:
Gateway Interface Distance Last Update
1.1.1.1 GigabitEthernet3/1 115 00:00:00
Distance: (default is 120)
Command (in SUM/CM) Description
show ip protocols [vrf <vrf-
name>]
Displays a detailed routing configuration.
To Next Page
Loading...
Need help?
General
