Alcatel-Lucent OmniAccess 5740 - SNMP Configuration Commands

System Configuration and Monitoring
Left running head:
Chapter name (automatic)
130
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
SNMP CONFIGURATION COMMANDS
The following commands are used to enable and configure SNMP in OmniAccess
5740 USG.
T
O ENABLE/DISABLE SNMP SERVICE
EXAMPLE
ALU(config)# snmp enable
ALU(config)# snmp disable
T
O CONFIGURE SNMP AGENT COMMUNITY
EXAMPLE
ALU(config)# snmp agent rocommunity private
ALU(config)# no snmp agent rocommunity
Command (in CM) Description
snmp enable This command is used to enable the
SNMP service.
snmp disable This command is used to disable the
SNMP service.
Command (in CM) Description
snmp agent {rocommunity
|rwcommunity} <community-string>
This command configures the SNMP
agent read-only/read-write
community.
no snmp agent {rocommunity
|rwcommunity}
This command removes read-only/
read-write community string
configured on the SNMP agent.