Alcatel-Lucent OmniAccess 5740 - IGMP Configuration Commands

Multicast Routing
Left running head:
Chapter name (automatic)
630
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
IGMP CONFIGURATION COMMANDS
To configure IGMP, perform the tasks described in the following sections. The
tasks in the first section are required; the tasks in the remaining sections are
optional, but might be required for your network.
T
O ENABLE MULTICAST ROUTING
EXAMPLE
ALU(config)# ip multicast-routing
T
O ENABLE IGMP ON AN INTERFACE
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip pim sparse-mode
Command (in CM) Description
ip multicast-routing This command enables multicast routing
and forwarding on OmniAccess 5740
USG.
Multicast routing is disabled by default.
Command (in ICM) Description
ip pim sparse-mode Enter this command in the Interface
Configuration Mode.
This command is used to enable IGMP
on an interface.
After enabling this command, IGMP
learns the multicast host information on
given interface.
no ip pim sparse-mode This command is used to disable IGMP
on an interface.