Factory Default Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
121
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
The factory default image on OmniAccess 5740 USG will have the following
configurations preconfigured [with the Serial card (USP -V.35/X.21/RS-232)
installed on the system]:
• HTTPS, SSH access to the system is enabled.
• Default user name and password (superadmin/admin, admin) is enabled with
‘enable’ password ‘admin’.
• SNMP v2 is enabled with read-only community.
• All interfaces will be in administratively ‘UP’ state.
• By default, DHCP client is enabled.
• The DHCP server is enabled on VLAN 1 with pool address from 192.168.1.2 -
254. A host connecting to the VLAN 1 interface receives an address between
192.168.1.2 and 192.168.1.254.
• VLAN 1 will have default IP address 192.168.1.1.
• All switchports will be part of default VLAN 1.
• By default, the serial interface comes up with PPP encapsulation with necessary
configuration to get IP address from the server.
TO RELOAD FACTORY DEFAULT CONFIGURATION
EXAMPLE
ALU(config)# reload factory defaults
System will boot with factory default configuration
ALL current config will be lost
Do you really want to continue (y/[n])?
Command (in CM) Description
reload factory defaults This command is used to reload OmniAccess
5740 USG with the factory default
configuration.
When this command is executed, the startup
configuration is erased, and the chassis is
rebooted with the factory default configuration.
To Next Page
Loading...
