T1E1 Line Card
Left running head:
Chapter name (automatic)
284
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T1 SHOW COMMANDS
TO VIEW THE CONTROLLER CONFIGURATION
The show controllers command displays the status of T1 controllers and displays
information about clocksources and other settings for the ports.
E
XAMPLE
ALU# show controller
T1 1/0 is administratively down.
T1 1/1 is administratively down.
T1 1/2 is up.
Line Card type is Channelized T1
Cablelength is long 0db
No Alarm Detected
Framing is esf, Line Code is b8zs, Clock Source is internal
Total Data (Since last clearing of counters)
0 Line Code Violation, 0 Framing Errors
0 Out of Frame, 0 Bit Errors
T1 1/3 is administratively down.
ALU# show controller T1 1/2
T1 1/2 is up.
Line Card type is Channelized T1
Cablelength is long 0db
No Alarm Detected
Framing is esf, Line Code is b8zs, Clock Source is internal
Total Data (Since last clearing of counters)
0 Line Code Violation, 0 Framing Errors
0 Out of Frame, 0 Bit Errors
Command (in SUM/CM) Description
show controller This command displays controller status
that is specific to the controller hardware.
To Next Page
Loading...
