T1 Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
285
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO VIEW INTERFACE CONFIGURATION
EXAMPLE
This example shows the details of the interface specified.
ALU# show interfaces Serial 1/2:0
Serial1/2:0 is up, line protocol is up
Internet address is 1.1.1.1/24
MTU 1500 bytes, BW 64 Kbit, DLY 0 usec,
reliability 0/255, txload 0/255, rxload 0/255
Loopback not set
Encapsulation hdlc, keepalive set (10 sec)
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue: 0/0 (size/max) 0 drops; Input queue: 0/0 (size/
max) 0 drops
Conversations: 0/0/0/0 (active/max active/max total)
Reserved Conversations: 0/0 (allocated/max allocated)
Available Bandwidth 64 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
7 packets input, 154 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
7 packets output, 154 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Timeslot(s) Used:1 (64Kbps each), Transmitter delay is 0 flag
s
Command (in SUM/CM) Description
show interfaces <name> This command displays the configuration
of the specified interface.
To Next Page
Loading...
