Alcatel-Lucent OmniAccess 5740 - MLPPP Show Commands

Multilink Point to Point Protocol
Left running head:
Chapter name (automatic)
378
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
MLPPP SHOW COMMANDS
TO VIEW MLPPP CONFIGURATION
EXAMPLE
ALU(config)# show interfaces mlppp 10
mlppp10 is up, line protocol is up
Internet address is 1.11.1.1/24
MTU 1494 bytes, BW 128 Kbit, DLY 0 usec,
reliability 255/255, txload 237/255, rxload 0/255
Encapsulation mlppp, loopback not set
IPCP: Initial
Last input never, output never, output hang never
Last clearing of "show interface" counters never
0 packets input (0 Control packets, 0 Data packets), 0 bytes
0 packets output (0 Control packets, 0 Data packets), 0 bytes
0 packets dropped, 0 giants received
Fragmentation: Fragment Delay 0 ms
0 fragmented, 0 couldn't fragment
0 fragments created, 0x0 sent sequence
Reassembly: Slippage MRU 32
0 fragments in reassembly list
0 lost fragments, 0 reordered
0 discarded fragments, 0 reassembled
0 lost received, 0 couldn't reassemble
0 fragments received, 0x0 received sequence
ALU(config)# show mlppp 10
MLPPP bundle 10 link state information:
IPCP: Open
MEMBER LINKS LCP AUTH CLIENT AUTH SERVER
Serial0/0:1 Open -----
Serial0/0:0 Open -----
Command (in SUM/CM/ICM) Description
show interfaces mlppp <1-256> Displays the configuration of the MLPPP
bundle interface specified.
show mlppp <1-256> Displays the PPP status on the member
links of the specified MLPPP bundle
interface.