Point-to-Point Protocol over Ethernet (PPPoE)
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
355
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
CHAPTER 16 POINT-TO-POINT PROTOCOL OVER
ETHERNET (PPPOE)
This chapter includes the commands for configuring Point-to-Point Protocol over
Ethernet (PPPoE) encapsulation on a Gigabit Ethernet interface. You are required
to refer to the “Ethernet Interfaces on SE” chapter before proceeding with this.
For instructions on using the PPPoE commands and descriptions on each of their
parameters, refer to the OmniAccess 5740 Unified Services Gateway CLI
Command Reference Guide.
The chapter is divided into the following sections:
• “PPPoE Overview”
• “PPPoE Configuration”
CHAPTER CONVENTIONS
Acronym Description
CM Configuration Mode - ALU (config)#
CPE Customer Premises Equipment
GigE Gigabit Ethernet
ICM Interface Configuration Mode - ALU (config-interface name)#
IPCP IP Control Protocol
LCP Link Control Protocol
PPP Point-to-Point Protocol
PPPoE Point-to-Point Protocol over Ethernet
PADI PPPoE Active Discovery Initiation
PADO PPPoE Active Discovery Offer
PADR PPPoE Active Discovery Request
PADS PPPoE Active Discovery Session-Confirmation
SUM Super User Mode - ALU#