EasyManuals Logo

Alcatel-Lucent OmniAccess 5740 Cli Configuration Guide

Alcatel-Lucent OmniAccess 5740
1225 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1065 background imageLoading...
Page #1065 background image
DHCP Server Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
1039
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
DHCP SERVER CONFIGURATION
This section includes the following:
“DHCP Server Configuration Steps”
“DHCP Server Configuration Flow”
“DHCP Server Configuration Commands”
“DHCP Server Show Commands”
DHCP SERVER CONFIGURATION STEPS
The following steps details the procedure to configure DHCP server on
OmniAccess 5740 USG:
Step 1: Configure an interface. Enter the Interface Configuration Mode.
ALU(config)# interface <name>
Example:
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)#
Step 2: Administratively bring up the interface
ALU(config-if <interface-name>)# no shutdown
Example:
ALU(config-if GigabitEthernet3/0)# no shutdown
Step 3: Configure IP address for the interface
ALU(config-if <interface-name>)# ip address {<ip-
address subnet-mask>|<ip-address/prefix-length>}
Example:
ALU(config-if GigabitEthernet3/0)# ip address
20.20.20.20/24
Step 4: Enable DHCP service. See “To Enable DHCP Service”
Step 5: Configure DHCP pool. See “To Configure DHCP Pool”
Configure network pool. See “To Configure a Network Pool”
Configure Network range for the pool. See “To Configure a Network
Range”

Table of Contents

Other manuals for Alcatel-Lucent OmniAccess 5740

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent OmniAccess 5740 and is the answer not in the manual?

Alcatel-Lucent OmniAccess 5740 Specifications

General IconGeneral
BrandAlcatel-Lucent
ModelOmniAccess 5740
CategoryGateway
LanguageEnglish

Related product manuals