Alcatel-Lucent OmniAccess 5740 - Configuration; V.35;X.21;RS-232 Interface Configuration Steps

V.35/X.21/RS-232 Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
291
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
V.35/X.21/RS-232 CONFIGURATION
Refer to the following sections to configure V.35/X.21/RS-232 interface on
OmniAccess 5740 USG:
• “V.35/X.21/RS-232 Interface Configuration Steps”
• “V.35/X.21/RS-232 Configuration Flow”
• “V.35/X.21/RS-232 Configuration Commands”
• “V.35/X.21/RS-232 DTE and DCE CLI Configuration Commands”
V.35/X.21/RS-232 INTERFACE CONFIGURATION STEPS
This section lists the instructions to configure V.35/X.21/RS-232 interface.
Step 1: Enter Configuration Mode
ALU# configure terminal
ALU(config)#
Step 2: Configure a Serial interface. See “To Configure a Serial Interface”
Step 3: Administratively bring up the interface. See “To Bring Up/Down a Serial
(V.35/X.21/RS-232) Interface”
Step 4: Configure IP address for the interface. See “To Configure IP address for
the Interface”
Step 5: Configure optional parameters for V.35/X.21/RS-232 DTE and DCE.
See “V.35/X.21/RS-232 DTE and DCE CLI Configuration Commands”
• Configure Clock Rate. See “To Configure Clock Rate”
• Configure CRC. See “To Configure CRC”
• Configure Clock Inversion. See “To Configure Invert Transmit Clock”
• Configure Loopback. See “To Configure Loopback”
• Set Encapsulation. See “To Set Encapsulation”
• Configure MTU. See “To Configure MTU (Maximum Transmission Unit)”
Step 6: See “Show Command” to view the interface configuration.