Alcatel-Lucent OmniAccess 5740 - Pppoe Configuration Commands

PPPoE Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
361
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
PPPOE CONFIGURATION COMMANDS
TO SET PPPOE ENCAPSULATION ON THE INTERFACE
This command is entered in the Interface Configuration Mode.
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# encapsulation pppoe
ALU(config-if GigabitEthernet3/0)# no encapsulation pppoe
Command (in ICM) Description
encapsulation pppoe This command sets the PPPoE
encapsulation on the Gigabit Ethernet
interface.
OmniAccess 5740 USG always acts as a
PPPoE client.
no encapsulation pppoe This command removes the PPPoE
encapsulation configured on the
interface.
This also removes the PPPoE server
given IP address, and restores the
configured IP address on the interface (if
any).