Alcatel-Lucent OmniAccess 5740 - Modify Global VRRP Group Parameters

Virtual Router Redundancy Protocol
Left running head:
Chapter name (automatic)
148
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
MODIFY GLOBAL VRRP GROUP PARAMETERS
It is recommended that the modifications to VRRP group global parameters are
done before enabling the VRRP group on the interfaces. Otherwise, this router
might become a master or a slave inadvertently before finishing the
customization.
For VRRP to be enabled on an interface for a group, the following three conditions
have to be met:
• The primary address of the interface must be configured.
• The operational state of the interface must be up.
• The primary address of the group must be configured.
T
O CONFIGURE VRRP ROUTER PRIORITY
Note: Priority cannot be changed for a VRRP group that is an IP address owner (i.e., VRRP
group address same as the interface address). The default priority for this group is set
to 255.
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# vrrp 7 priority 104
Command (in ICM) Description
vrrp <1-8> priority <1-254> This command sets the priority for the
router for a specific VRRP group.
no vrrp <1-8> priority The “no” command restores the default
priority for the VRRP group.
The default priority is 100.