Alcatel-Lucent OmniAccess 5740 - Page 175

VRRP Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
149
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO CONFIGURE PRE-EMPTION TO THE VRRP GROUP
Note: Pre-emption is enabled by default.
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# vrrp 7 preempt
ALU(config-if GigabitEthernet3/0)# no vrrp 7 preempt
T
O DESCRIBE A VRRP GROUP
Note: User-defined string up to 80 characters is allowed.
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# vrrp 7 description ALU-vrrp
Command (in ICM) Description
vrrp <1-8> preempt This command enables the preempt mode.
By enabling the preempt mode, the
configured router takes over as the master of
a group if it has a higher priority than the
existing master virtual router.
no vrrp <1-8> preempt The “no” form of the above command
disables pre-emption of the VRRP group.
Command (in ICM) Description
vrrp <1-8> description
<string>
This command assigns a text description
to the VRRP group.