Open Shortest Path First
Left running head:
Chapter name (automatic)
606
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
Example 13:
ALU# show ip ospf virtual-links
Virtual Link VLINK to router 6.6.6.6 is up
Run as demand circuit
DoNotAge LSA not allowed
Transit area 1, via interface GigabitEthernet3/1, Cost of using 1
Transmit Delay is 1 sec, State POINT-TO-POINT
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:04
Adjacency state FULL
Retransmission queue length 2, number of retransmission 0 ALU#
CLEAR COMMANDS IN OSPF
TO RESTART AN OSPF PROCESS
To restart an OSPF process, use the following command:
Command (in SUM/CM) Description
clear ip ospf [[<1-65535>
|process|redistribution|counters
[neighbor] [neighbor-id]
[interface-name]|interface
statistics [hello|ddp|lsupd
|lsack|lsreq][<interface-name>]]
Restarts OSPF router if only process
ID is specified.
For other parameters, it restarts the
specified counters/feature.
To Next Page
Loading...
