Alcatel-Lucent OmniAccess 5740 - Configuration Steps

Dynamic DNS (DDNS) Client
Left running head:
Chapter name (automatic)
1108
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
CONFIGURATION STEPS
ON OA5740-A
Step 1: Tunnel configuration
a) Configure a tunnel interface
OA5740-A(config)#interface tunnel1
OA5740-A(config-if Tunnel1)# ip address 192.168.0.1/24
OA5740-A(config-if Tunnel1)# no shutdown
b) Specify tunnel end-points
OA5740-A(config-if Tunnel1)# tunnel source 2.2.2.1
OA5740-A(config-if Tunnel1)# tunnel destination 2.2.2.3
Step 2: DNS client configuration
a) Enable domain lookup on the OmniAccess 5740 USG.
OA5740-A(config)# ip domain-lookup
b) Specify name server to which the requests are to be sent.
OA5740-A(config)# ip name-server 135.250.20.2 primary
Step 3: DDNS client configuration
a) Configure DDNS method, DDNS protocol type, and DDNS server parameters
for a method.
OA5740-A(config)# ip ddns update method myDdnsObj
OA5740-A(config–ddns-myDdnsObj)# http
OA5740-A(config-ddns-HTTP)# server members.dyndns.org
username myMembername password myMemberPass
b) Apply DDNS configuration on an interface - Configure DDNS host name and
apply DDNS method on an interface.
OA5740-A(config)# interface Serial 0/0
OA5740-A(config-if Serial0/0)# no shutdown
OA5740-A(config-if Serial0/0)# ip address 2.2.2.1/24
OA5740-A(config-if Serial0/0)# ip ddns update hostname
mysmb.dyndns.org
OA5740-A(config-if Serial0/0)# ip ddns update method
myDdnsObj