Multilink Frame Relay
Left running head:
Chapter name (automatic)
384
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
ALCATEL-LUCENT SPECIFIC OVERVIEW ON MLFR FEATURES
The following features are available with the current release:
• The OmniAccess 5740 USG supports FRF 16.1 (Multilink Frame Relay UNI/NNI
Implementation Agreement) without necessarily conforming to all the optional
items mentioned in the specification.
• Specifically, the system will support the logical aggregation into a configured
MLFR bundle to support any number of interfaces, including channelized and
fractional serial interfaces. This bundle will behave like a virtual IP interface.
• Multiple MLFR bundles can be statically configured on the system. However,
bundles will not be created dynamically. MLFR protocol negotiation or data
reaching the system on an unconfigured interface will be dropped. Bundles
cannot be deleted, but can be shut down and thereby made unusable.
• Without any QoS configuration applied on the MLFR bundle, the packet
distribution across the MLFR member links within a bundle will be handled in a
round robin fashion.
• The bundle identifier and the link identifier will be configurable, as will the values
of certain protocol timers and counters.
• IP routing protocols as well as policies such as ACL, NAT, IDS, IPsec, QoS, etc.,
may be applied on the bundle.
• The Alcatel-Lucent OmniAccess 5740 USG implementation does not include Link
Fragmentation and Interleaving, Vendor Extension Information Element, and
SNMP MIB support.
MLFR CONFIGURATION
• “MLFR Configuration Steps”
• “MLFR Configuration Flow”
• “MLFR Configuration Commands”
• “MLFR Show Commands”
To Next Page
Loading...
Need help?
General
