Alcatel-Lucent OmniAccess 5740 - Interface Show Commands

Configuring Interfaces
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
35
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
INTERFACE SHOW COMMANDS
TO VIEW THE DETAILS OF ALL INTERFACES OR A SPECIFIC INTERFACE
EXAMPLE 1
ALU# show interfaces GigabitEthernet 3/0
GigabitEthernet3/0 is up, line protocol is down
Hardware is Intel 82546, address is 0011.8b00.86a8
(0011.8b00.86a8)
Internet address is 172.16.2.1/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 0 usec,
reliability 0/255, txload 0/255, rxload 0/255
Loopback not set
Encapsulation ARPA, keepalive not set
Auto-duplex(Unknown), Auto(Unknown), 1000BaseTx/Fx
ARP type: ARPA, ARP Timeout never
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/0 (size/max), 0 drops; Input queue 0/0 (size/
max), 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer copied, 0 interrupts, 0 failures
Command (in SUM/CM) Description
show interfaces [<name> <slot/
port:channel.subchannel>]
This command displays the information
of all the interfaces configured.
If the interface name is specified, then
the information for the specified interface
is displayed.
show interfaces brief This command displays information of all
the IP and non-IP interfaces configured.