Alcatel-Lucent OmniAccess 5740 - Page 309

T1 Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
283
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO SET ENCAPSULATION ON THE INTERFACE
EXAMPLE
ALU(config-if Serial0/0:0)# encapsulation frame-relay
ALU(config-if Serial0/0:0)# no encapsulation
T
O CONFIGURE MTU ON THE INTERFACE
EXAMPLE
ALU(config-if Serial0/0:0)# mtu 100
ALU(config-if Serial0/0:0)# no mtu
Command (in ICM) Description
encapsulation {frame-relay|
ppp|hdlc|mlfr <bundle_id>|
mlppp <bundle_id>}
This command is entered in the interface
configuration mode to set encapsulation
to the interface.
no encapsulation The “no” command sets the
encapsulation to its default.
The default encapsulation is HDLC.
Command (in ICM) Description
mtu <64-1500> This command is used to configure the
MTU value on the serial interface, i.e., the
maximum size of the transmitted layer 2
payload.
no mtu The “no” command sets the MTU to its
default.
The default MTU is 1500 bytes.