Alcatel-Lucent OmniAccess 5740 - Page 659

IGMP Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
633
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO CONFIGURE IGMP QUERY MAX RESPONSE TIME
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip igmp query-max-response-
time 20
T
O JOIN MULTICAST GROUP
Router can join a group by using this command. This helps in keeping PIM states
always active even if no host is interested in the group. This command also helps
in debugging multicast routing.
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# ip igmp join-group 226.2.2.2
T
O CONFIGURE IGMP ACCESS GROUP
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip igmp access-group 10
Command (in ICM) Description
ip igmp query-max-response-time
<1-25>
This command configures the
maximum response time (in seconds)
advertised in IGMP queries.
The default query-max-response-
time is 10 seconds.
Command (in ICM) Description
ip igmp join-group <group-
address>
This command is used to join
specified multicast group.
Command (in ICM) Description
ip igmp access-group {<1-
99>|<access-list-name>}
This command is used to deny
groups, which are not permitted by
access-lists. This restricts the host on
a subnet joining only multicast groups
that are permitted by access-lists.