Alcatel-Lucent OmniAccess 5740 - Page 389

PPPoE Configuration
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
363
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
TO CONFIGURE ACCESS CONCENTRATOR NAME
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# pppoe ac-name ISP123
ALU(config-if GigabitEthernet3/0)# no pppoe ac-name
Note: The access concentrator name configured on OmniAccess 5740 USG should match
the concentrator name of the server.
T
O INITIATE PPPOE NEGOTIATION MANUALLY
Note: PPPoE negotiation is automatically started when the link is administratively brought
up on a PPPoE interface. It starts off by sending a PADI.
Also, whenever “encapsulation pppoe” is configured on an administratively up GigE
interface.
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# pppoe negotiate
Command (in ICM) Description
pppoe ac-name <access-
concentrator-name>
This command is used to configure the
access concentrator name of the PPPoE
server.
no pppoe ac-name The “no” command removes the access
concentrator name configured.
Command (in ICM) Description
pppoe negotiate This command is used to initiate the
PPPoE negotiation on the interface.
This command helps to terminate the
existing PPPoE session, if any, and re-
negotiate the session.