Alcatel-Lucent OmniAccess 5740 - Page 390

Point-to-Point Protocol over Ethernet (PPPoE)
Left running head:
Chapter name (automatic)
364
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O SET TIMER FOR RETRANSMISSION OF PADI/PADR PACKETS
E
XAMPLE
ALU(config-if GigabitEthernet3/0)# pppoe retry-timer 15
ALU(config-if GigabitEthernet3/0)# no pppoe retry-timer
Command (in ICM) Description
pppoe retry-timer <0-300> This command sets the initial timer
for re-transmission of PPPoE PADI/
PADR packets in the absence of a
PADO/PADS from a server.
Wait period doubles between
successive PADIs. However, after
three unanswered PADIs, wait period
is reset to configured retry-timer.
If the retry-timer value is set to ‘0’,
PPPoE client sends only one PADI/
PADR. With max-retry value ‘0’
(default), PPPoE client keeps
sending PADIs till a PADO is
received.
no pppoe retry-timer The ‘no’ command resets the retry-
timer to its default.
The default retry-timer value is 10
seconds.