Point-to-Point Protocol
Left running head:
Chapter name (automatic)
338
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O SET MAX UNANSWERED ECHO REQUESTS
E
XAMPLE
ALU(config-if Serial0/0:0)# ppp lcp max-echo 20
ALU(config-if Serial0/0:0)# no ppp lcp max-echo
T
O SET LCP RESTART INTERVAL
EXAMPLE
ALU(config-if Serial0/0:0)# ppp timeout restart-interval 10
ALU(config-if Serial0/0:0)# no ppp timeout restart-interval
Command (in ICM) Description
ppp lcp max-echo <0-30> This command denotes the maximum
number of unanswered LCP echo
requests sent before LCP decides that
the peer is down.
The value “0” implies that the link will
not be brought down on the basis of
unanswered echo requests.
no ppp lcp max-echo The “no” command sets the maximum
number of unanswered LCP echo
requests to is default, i.e., 5.
Command (in ICM) Description
ppp timeout restart-interval <0-
255>
This command defines the interval
after which the LCP/NCP negotiation
will be reattempted after it is
terminated.
no ppp timeout restart-interval The “no” command sets the LCP/
NCP restart-interval to its default.
The default LCP/NCP restart-
interval is 30 seconds.
To Next Page
Loading...
