Switching Overview
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
181
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
• If an interface is set to either hybrid/ trunk mode, the interface can be set to
access mode by issuing the command “no switchport mode trunk/hybrid”,
provided access configuration exists. If no access configuration exists, interface is
set to pure bridging mode.
• In the Hybrid mode, if a VLAN is configured as both native VLAN and Trunk
VLAN, native VLAN takes precedence.
• If no mode is configured on the switchport, and if no access VLAN configuration
exists on the switchport, the switchport will be in pure bridging mode. In this mode,
packets are bridged across other switchports of pure bridging mode based on the
mac-address table, without considering the VLAN tag information.
Note: MTU configuration is not supported on switchport interfaces. However, MTU can be
configured on VLAN interfaces.
To Next Page
Loading...
Need help?
General
