Alcatel-Lucent OmniAccess 5740 - Page 212

Layer 2 Switching Configuration
Left running head:
Chapter name (automatic)
186
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE VLAN FOR ACCESS MODE
E
XAMPLE
ALU(config-if switchport1/0)# switchport access vlan 10
ALU(config-if switchport1/0)# no switchport access vlan
T
O CONFIGURE TRUNK VLAN
E
XAMPLE
ALU(config-if switchport1/0)# switchport trunk allowed vlan 3
ALU(config-if switchport1/0)# switchport trunk allowed vlan 5 8
9
ALU(config-if switchport1/0)# no switchport trunk allowed vlan
3 5
Command (in ICM) Description
switchport access vlan <2-
4094>
This command is used to configure
VLANs for access mode in the range 2-
4094.
no switchport access vlan This command deletes the access
VLANs configured on the interface.
This makes it to switch over to the pure
bridging mode.
Command (in ICM) Description
switchport trunk allowed
vlan <2-4094>...
This command is used to configure VLANs
for trunk mode in the range 2-4094.
Multiple VLANs can be configured.
no switchport trunk allowed
vlan <2-4094>...
This command deletes the trunk VLANs
configured on the interface.