Layer 2 Switching Configuration
Left running head:
Chapter name (automatic)
188
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
T
O CONFIGURE DUPLEX OPERATION
EXAMPLE
ALU(config-if switchport1/0)# duplex full
ALU(config-if switchport1/0)# no duplex
T
O CONFIGURE SPEED
EXAMPLE
ALU(config-if switchport1/0)# speed 100
ALU(config-if switchport1/0)# no speed
Command (in ICM) Description
duplex {auto|full|half} This command configures duplex
operation on an interface.
no duplex The “no” command sets the duplex
mode to its default.
The default duplex mode is “auto”.
Command (in ICM) Description
speed {10|100|1000|auto} This command configures the interface
speed.
no speed The “no” command sets the interface
speed to its default.
The default speed is “auto”.
To Next Page
Loading...
