Frame Relay
Left running head:
Chapter name (automatic)
322
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide
Alcatel-Lucent
Example:
ALU(config-if Serial0/0:0.1)# ip address 124.123.10.1
255.255.255.0
Step 4: Repeat Step 11 (DLCI configuration) as given in the section “Frame Relay
Configuration Steps”
Note: If you are configuring FR on a sub-interface on a Serial interface (V.35/X.21),
configure a sub-interface using the following command:
ALU(config)# interface Serial <slot/port>.subchannel
ALU(config-if Serial<slot/port.subchannel>)#
Example:
ALU(config)#interface Serial0/0.1
ALU(config-if Serial0/0.1)#
To Next Page
Loading...
